| From: | Derek Lawson |
| Date: | 16 Jun 2000 at 14:33:28 |
| Subject: | Catweasel Controller |
I just purchased a Mark II Zorro Catweasel controller and I am having
problems getting it installed. My system specs are as follows:
Amiga 2000 running OS 3.5
Derringer '030/50 no fpu 32mb fast ram
Picasso II 1mb
GVP 4008 SCSI controller w/1gb hard drive
Commodore flicker fixer/doubler
Ariadne II
I managed to get the card installed successfully along with a
high-density TEAC floppy. I installed the software and followed all
prompts correctly. I chose to have the following drives mounted at
startup, Amiga DD, Amiga HD, PC DD, PC HD, and PC Extra.
When I boot, the floppy drive will only recognize Amiga formatted floppy
disks. For some reason, I cannot read, write, or format a blank HD
floppy. I went through the software installation again and again with
the same results.
The odd thing is when I check /DEVS/DOSDrivers, I see the PC floppy
drivers. I looked through the documetation and I'm not having much luck.
Can anyone assist me on this?
Thanks in advance.
[Non-text portions of this message have been removed]
------------------------------------------------------------------------
Old school buds here:
http://click.egroups.com/1/5536/3/_/644178/_/961162395/
------------------------------------------------------------------------