From: farren@shore.net (Mike Farren) Newsgroups: comp.sys.amiga.hardware Subject: Re: C= 3070 tape drive (Caliper 150) SCSI ID? Date: 30 Mar 1996 01:09:57 -0500 "Antti J. Roppola" writes: >The Caliper 150 (the guts of the 3070) has a dip switch block on the >side labelled 1-9 (or was that 1-10?). I presume three of these >switches should set SCSI ID. The question is which ones and how? Here's the switch info - Off is 0, On is 1: 1 - SCSI ID LSB 2 - SCSI ID 3 - SCSI ID MSB 4 - Parity 5 - Drive Type LSB 6 - Drive Type 7 - Drive Type 8 - Drive Type MSB (these should be 0, 0, 1, 1 for the CP150) 9 - Hard Reset 10 - No Connection -- Michael J. Farren, Ex-Lemmings Manager | All standard disclaimers apply. Currently unemployed - know anyone | looking for a good game programmer? | Are we not Lemmings? If you click farren@shore.net, farren@well.com | us, do we not ... Oh, no! From: mariodoc@mbox.vol.it (Mario Dell'Oca) Newsgroups: comp.sys.amiga.hardware Subject: Re: C= 3070 tape drive (Caliper 150) SCSI ID? Date: 4 Apr 1996 05:06:05 GMT In article dated < 29-Mar-96 04:08:23 >, about < C= 3070 tape drive (Caliper 150) SCSI ID? >, Antti J. Roppola < ajr@henric.nric.gov.au > wrote: >The Caliper 150 (the guts of the 3070) has a dip switch block on the >side labelled 1-9 (or was that 1-10?). I presume three of these >switches should set SCSI ID. The question is which ones and how? From the Installation Guide booklet for A3070: ... 8. Locate and adjust the thumb switch on the side of the tape drive. The switch configuration (as set to SCSI device 4) should look like this: SW1 1 2 3 4 5 6 7 8 9 10 OFF X X X X X ON X X X X X only the switches 1 trough 3 need to be altered to change the SCSI ID. These are the left-most switches. The remaining seven switches should be left in place.... To set the SCSI id use this chart: ID SW1-1 SW1-2 SW1-3 0 OFF OFF OFF 1 ON OFF OFF 2 OFF ON OFF 3 ON ON OFF 4 OFF OFF ON (default configuration) 5 ON OFF ON 6 OFF ON ON 7 ON ON ON /\/\ Mario Dell'Oca, M.D. / /__\ E-mail: mariodoc@mbox.vol.it, mariodoc@iol.it