Pace 56 Solo Upgrade Utility (Amiga version), Firmware release V2.04 ==================================================================== DISCLAIMER ---------- You should be aware that there is an extremely slim chance that this upgrader could fail, resulting in "dead" Solo modem :-( Normally, should this occur, Pace would repair/replace the defective unit for free, under warranty. However, since PMC Electronics have gone into receivership, this is no longer the case - you will not be able to get your Solo repaired. Therefore, any use of this upgrader will be at your own risk - I (Oliver Roberts) cannot be held responsible for any damage to your Solo modem. FYI, the same risk applies to the PC version of the upgrader. Minimum requirements -------------------- Amiga computer equipped with a 68020 cpu, OS 2.04, 2Mb free ram. (recommended: OS 3.x, fast third-party serial port) Serial port speed ----------------- It is extremely IMPORTANT that you set the serial speed correctly for your system. If you will be performing the upgrade via the Amiga's internal serial port, you MUST NOT set the speed above 38400, otherwise this upgrader is likely to fail! Unless you own a fast CPU (040/060), you should leave the speed at the default (19200). However, if you are using a fast third-party serial port (e.g. Surf Squirrel, Whippet, I/O Extender, Multiface, HyperCOM, etc), you can safely set the speed to 115200 bps. The light show -------------- At various stages during the upgrade process, the 5 backlit buttons will flash, as well as the send/receive lights. This is normal, so there's no need to worry when this happens! During the firmware upgrade stage, the send light will mostly be on, and when complete the 5 backlit buttons will light up for a few seconds. During the loading of messages the backlit buttons will cycle from left to right, and the send/receive lights will flash as the data is transferred. If the "Flash init." option is enabled, the backlit buttons will cycle from right to left for approximately 1 minute soon after the loading of messages stage has started, before reverting to the left to right sequence. This is only a rough guide - the exact sequence may be different depending on the current firmware version of your modem. Firmware release history ------------------------ V2.04 Improved compatibility with certain V.90 ISP's V2.03 Improved V.90 connections and fax receive capability V2.02 Improved stability and speakerphone performance V2.01 Improved fax send capability V2.00 V.90 capability V1.00 First code release Author ------ Amiga version by Oliver Roberts - Copyright © 1998-1999, All Rights Reserved. Based on the original PC code courtesy of PMC Electronics Ltd. Please send bug reports concerning this upgrader to oliver.roberts@iname.com Pace 56 Solo help can be found at http://www.nanunanu.org/~oliver/soloup/ Thanks to Andy Thomson, Don Cox, Tim Grainger, Will Stanton, Simone Tellini and Ben Vost for beta testing this software.