3. System requirements, compatibility

- 1 Amiga (or more :-) or the Amiga-emulator UAE
- Kickstart/Workbench 2.04 or higher
- Helvetica 11 - font in the FONTS:-directory
- about 230 kB free memory
- a minimum workbench screen hight of 256 pixels

There shouldn´t be any problemes if these requirements are fulfilled
(please read the notices at the end of this section!).
TextConv V1.51 has been tested with the following configurations:

1) SCT Amiga2000C mode 1:
   Base Amiga 2000C, Kickstart/Workbench 2.04, 2.1, 3.1
   2MB chip RAM, ECS Graphics via Multivision2000 flickerfixer
   Blizzard 2060/50, 28MB RAM, Blizzard SCSI-controller
   PicassoII gfxboard (original Picasso WB-emulation and Shareware-
   CybergraphX-emulation)

2) SCT Amiga2000C mode 2:
   Base Amiga 2000C, Kickstart/Workbench 2.04, 2.1, 3.1
   2MB chip RAM, ECS Graphics via Multivision2000 flickerfixer
   Original MC68000, 7.14MHz, BSC Tandem IDE HD
   FastRAM-configurations:
   - 0MB FastRAM
   - 2MB FastRAM from PicassoII with APM (Add Picasso Mem)
   - 4MB FastRAM from GoldenGate486SLC/2 Bridgeboard with "moremem"

3) SCT UAE 0.68c for MS-DOS
   Intel Pentium PC, 75/100/166MHz, 48MB RAM
   MS-DOS 7.0, Windows 95, OS/2 Warp4
   Kickstart/Workbench version 3.1
   UAE-configuration: 68000 and 68020-version,
   system requirements from above must be fulfilled.

4) SCT UAE 0.68 Rel.14 for Windows
   Intel Pentium PC, 166MHz, 48MB RAM
   Windows95, DirectX 3.0
   Kickstart/Workbench version 3.1
   UAE-configuration: 68020-version,
   system requirements from above must be fulfilled.

5) MDS UAE 0.68c for MS-DOS
   Intel Pentium PC, 150MHz, 32MB RAM
   MS-DOS 7.0, Windows 95
   Kickstart/Workbench version 3.1
   UAE-configuration: 68000 und 68020-version,
   system requirements from above must be fulfilled.

Notice 1:
The GUI is designed for WB-resolutions with a 4:3-proportion
(e.g. Hires-Interlace, Productivity, (S)VGA-resolutions from
GFX-boards). Such a mode isn´t necessary, but it looks much better;-)

Notice 2:
In case of an access to a CrossDos-drive the CrossDos-commodity
(Note: the commodity, not the driver) MAY NOT BE ACTIVE,
because this commodity also makes a (partial) conversion of textfiles
like the way TextConv does. This leads to results that are not
desired. Files that have been converted with the CrossDos-commodity
usually can´t become further processed via TextConv, because the
conversion that CrossDos does is too inaccurate.

Notice 3:
If text should be transfered to the Mac-emulator ShapeShifter via
Clipboard, the format of these texts has to be Amiga-ACSII-format,
because ShapeShifter converts text to the Mac-format itself when
they are imported from the Amiga-clipboard.