;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;
;
;   Login script for terminating an AmiTCP/SLIP connection using
;   IPDial
;
;   Version 1.1,    06.12.1994
;
;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;
;
;   The line below *must* be present and *must* be the first command
;   line in the script. It specifies the device and the protocol to
;   use. (Possible protocols are 7WIRE ( =RTSCTS), XONXOFF or NONE.)
;   You may omit the protocol, in which case the defaults of the
;   serial.device are used.
;
;   Be sure, that the parameters you are using in this script are the
;   same as used for initializing AmiTCP/IP!

    DEVICE serial.device 7WIRE UNIT 0


;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;
;
;   Certain settings (Note, that these override the respective settings
;   of the serial.prefs.)
;
;   Possible settings are:
;	BAUD		Baudrate, integer
;	DATABITS	number of data bits, integer
;	STOPBITS	number of stop bits, integer
;	BUFSIZE 	Read buffer size, integer
;	PARITY		one of NONE, ODD or EVEN
;
;   These are scanned with ReadArgs(), thus you can either use the syntax
;	set BAUD=38400
;   or, if you prefer, this version
;	set BAUD 38400
;   In the first case, however, it is important, that you omit blanks.
;

    set BAUD=38400 DATABITS=8 STOPBITS=1 BUFSIZE=4096

;   Possible settings in the following line are:
;	NONE EVEN ODD

    set PARITY=NONE


;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;

DELAY 2
SEND +++
DELAY 2
SEND ATH0\r
ECHO "Disconnected.\n"
EXIT 0