This Disk contains a Printer Driver for use with the Canon BJ- 300/330 Bubble Jet Printer Series and Commodore Amiga Computers. The driver is designed for use when the BJ-300/330 is configured for IBM Proprinter mode. ie SW1-1 and SW1-2 are set to on. Contents The following files are included on the disk: Canon BJ300 - Printer Driver revision 1.3 Readme - This file Notes Setup and connect your BJ-300/330 as described in the BJ- 300/330 Users Manual. Set the printers DIP Switches SW1-1 and SW1-2 to the ON position all other switches may be left at default or customised appropriately. General Printer Driver Information 1. Bubble Jet black/white and grey scale printer. 2. The driver supports the following graphics dump densities. Density X-DPI Y-DPI X*Y-DPI 1 360 360 129600 2 180 180 32400 3 120 360 43200 4 180 360 64800 5 240 360 86400 6 360 180 64800 7 360 360 1296000 3. A PaperSize of 'Wide Tractor' selects a maximum print width of 13.6" this is applicable to the wide carriage BJ-330 printer only. 4. A PaperType of "Single" ejects a sheet with a Form Feed after every print. 5. This driver automatically checks for the processor in use and optimizes the print routines accordingly. Hints and Tips 1. If using Pagestream 2.1 select density 0 to obtain 360x360 DPI resolution and not density 6. 2. If your output is striped or misses print lines then check your printers DIP switch settings and software setup values. Check especially page settings such as margins. 3. Data should only be sent to the printer either via parallel.device (par:) or printer.device (prt:) and not both together as this may confuse the printer. The driver is available via modem: WildCat FIDO 2:243/43 ++49-6173-2544 (Germany) 1200-14400 bps HST/V32/V32.bis SETTING: 8N1