This program works on Workbench 1.3, 2.04 and 3.0.

    MrCopper Version 2.6
    ~~~~~~~~~~~~~~~~~~~~
A little program which puts nice copper bars on the current screen
(i.e. Workbench), there are two ways to use it :

1 >>> Click on its icon and a window will appear with 6 buttons like :

      [ << ] [ >> ] [ Exit ]
       (1)    (2)    (3)

      [ << ] [ >> ] [ About]
       (4)    (5)    (6)

  1 and 2 ; Allow you to cycle through the preset colour sets.
            The number on the left of button (1) is the current set.

  3 ; Exits the program and leaves the current copper pattern on the screen

  4 and 5 ; Change the colour to accept the copper bars (0-3) 0=background
            The number on the left of colour 4 is the current colour.

  6 ; So you don't forget who wrote it.

2 >>> From the CLI

      If you type < mrcopper2.6 > then it will load the save as above

      but

      You can execute it with the following parameters :

      mrcopper2.6 [colourset]:[register]

      where :

      'colourset' is the pattern number 00-25

         00 ; White -> Purple
         01 ; White -> Yellow
         02 ; White -> Yellow (With Greys Bits!)
         03 ; Blue -> Yellow
         04 ; Blue -> Purple
         05 ; Yellow -> Purple
         06 ; Yellow -> Blue
         07 ; Yellow -> Green
         08 ; Red -> Blue
         09 ; Red -> White
         10 ; Red -> Cyan
         11 ; Red -> Yellow
         12 ; Red -> Purple
         13 ; Purple -> Green
         14 ; Green -> White
         15 ; Green -> Purple
         16 ; Green -> Red
         17 ; Green -> Yellow
         18 ; Pink -> L. Green
         19 ; Blue -> L. Yellow
         20 ; Horizontal Grey Bars
         21 ; Horizontal Yellow Bars
         22 ; Horizontal Red Bars
         23 ; Horizontal Purple Bars
         24 ; Horizontal Green Bars
         25 ; Horizontal Grey, Yellow, Red, Purple And Green Bars

      'register' is the register to accept the copper bars 0-3.

  so to give the background a yellow - green fade :

        mrcopper2.6 10:0

  or to give a black - red fade on the window border (colour 3)

        mrcopper2.6 07:3

This program was written with GFA-Basic 3.5 and compiled using the
GFA-Basic Compiler 3.51E.

If you find any bugs or would the source code then please write off to the
following address (some cash would be nice if you want the source code):

   Paul Alan Freshney
    8 Richmond Close
     Balderton
      Newark
       Notts.
        NG24 3EX

----------------------------------------------------------------------------
                      (C) Paul Alan Freshney 1995
----------------------------------------------------------------------------