For NoteBook file viewer version 1.0 - December 11th, 1991
        ==========================================================

To install the NoteBook Viewer, perform the following steps. They assume
that you have un-lharced the file into RAM:, and that you have room on
your working partition for the viewer. Installation requires about 100k
of free disk space. If you like, you can "Power-Pack" the viewer; this
will save a considerable amount of disk space, but will cause the program
to startup quite a bit slower.

    1 - go to the ram: device;
    
            cd ram:
            -------

    2 - copy the file "swall.font" to your "fonts:" assignment;
    
            copy swall.font TO fonts:
            -------------------------

    3 - make a directory to contain the font;
    
            makedir fonts:swall
            -------------------

    4 - copy the file "9" to "fonts:swall"
    
            copy 9 TO fonts:swall
            ---------------------

    5 - copy the veiwer program to your c: directory;
    
            copy NBView TO c:
            -----------------

    6 - copy the viewer ICON to the location where you
        want it. For instance, if you want the viewer
        available from the root of your harddrive, and
        your hard drive has the name "DH0:", then you
        would type;
        
            copy NBView.info TO DH0:
            ------------------------
        
        This assumes that you use a NON-interlace WorkBench screen
        under OS 2.0. If you use an interlace mode screen, use the
        other ICON we have provided, this way;
        
            copy NBViewL.info TO dh0:NBView.info
            ------------------------------------
        
        Please be aware that the previous command actually
        renames the icon - type it exactly or it won't work.

        NOTE: Under the current release of the Amiga operating
              system, you can place the ICON for the NBView
              software anywhere and it will find the NBView
              program in c: automatically. Under 1.3, the ICON
              must be in the same location as the program. The
              installation instructions assume you are using
              the 2.0 release of the operating system.

This complete the installation of the viewer software. You can invoke the
viewer from the CLI or SHELL by typing;

    NBView <filename>

Where <filename> is the name of a valid NoteBook file.

From the WorkBench, the usual selection proceedures work.

The viewer can also load notebook files from inside when it is started
without a notebook file.

To automatically load the viewer, attach an ICON to the notebook file
and set the default tool to "c:NBView".

Have fun!

Black Belt Systems Tech Support