HeadCleaner V37.2

                    Copyright Richard Waspe 1994


  HeadCleaner is for cleaning your floppy disk drive heads :-)

  It works by stepping the heads in across the cleaning surface of
  the head cleaning disk, thus continually exposing the heads to
  fresh uncontaminated cleaner, whilst greatly increasing the life of
  your cleaning disk, by not continually using the same track.

  HeadCleaner can be run from the CLI or WB, but requires at least
  V37, 2.04+ of the Operating system. The Gadget driven interface is
  fairly intuitive. No harm should come to any disks left in the
  drives, and they will be re-read after HeadCleaner has run, but if
  your data is precious, then remove them to be sure. When
  HeadCleaners window opens, apply a small amount of cleaning fluid
  to your head cleaning disk and insert into the drive to be cleaned.
  Click on the Gadget for that drive. There are four Gadgets, one
  each for DF0: DF1: DF2: and DF3: . The Gadgets will only be active
  for those drives found to exist in your system. The others will be
  'ghosted' out.

  The drive light will come on, and as the cleaning disk spins, the
  heads will step across it's surface for about 20 seconds. During
  this time all Gadgets will be inactive, and progress of the
  cleaning is shown by a bar in the lower part of the window. When
  the cleaning is finished, the screen will flash, and the gadgets
  will again be active. At this time you may continue to clean other
  drives in the same manner. When you have finished, remove the
  cleaning disk and click on the close gadget in the top left of the
  window.

  The user interface was designed with GadToolsBox By Jan v.d. Baard,
  and the program compiled with SAS/C V6.3 on a WB3 A2000/030/33

  This software is Copyright Richard Waspe 1994, but may be freely
  distributed other than by magazine coverdisk. No warranty or
  suitability for purpose is implied or given, and the it's use is
  entirely at your own risk. I accept no responsibility for any
  personal injury, loss or damage, consequential or otherwise as a
  result of using it.

  No magazine may publish this software on a coverdisk without my
  express permission in writing or by EMail.

  You can contact me at the following EMail addresses :

  waspy@cix.compulink.co.uk
  rwaspe@hamlet.adsp.sub.org
  Fidonet 2:252/309.40

  Richard Waspe