Subject: Bearcat Mods
Concerning the Uniden Bearcat 760xlt, the mod for the 950xlt does work
to restore lost freq. Disconnect pin 20 of the microprocessor from the
circuit board and connect it to pin 19. I bent the pin slightly and cut it with the scissors of a swiss army knife then soldered an 1/8 lead cut from a cap across the pins near the top of the chip. I've yet to find any problem with this mod. But as always do so at your own risk.     73 Mike WA2E @ K2DLJ

BC760XLT

THE FOLLOWING "MAGICAL" MODIFICATION WILL ALLOW RECEPTION OF CELLUAR PHONE BAND ON A BEARCAT 760XLT. NOTE- THIS MODIFICATION SHOULD BE PERFORMED BY SOMEONE VERY FAMILIAR WITH ELECTRONIC COMPONETS.  THIS WILL ALSO VOID YOUR WARRANTY.  AUTHOR ASSUMES NO RESPONSIBILITY WHATSOEVER.

1- Disconnect power cord from wall outlet, remove the four screws
   holding the bottom cover on.  Remove bottom cover carefully,           speaker wires are attached.

2- Locate the large 64 pin microprocessor chip near front of the          radio Noting the indented dot which marks pin one, count along row     to pin 20. Cut that pin close to the circuit board so if you ever      want you could tack solder it back together. 

   Chip im my unit has following numbers:
   7D3
   HD 40740085
   JAPAN

3-  Temporarily reconnect power to the radio and attempt to program        845.000 Mhz., confirming cellur band restoration.  Frequencies may     be entered in 12.5 Khz, not 30 Khz, increments.

4- This completes the magical instructions, disconnect power,             reassemble scanner in reverse order.  Rember performing this magic     voids your warranty, not to mention the fact it is illegal and if      the King's "henchmen" catch you, you may be severely fined or maybe   even thrown into dungeon.

PORTED AND REALIGNED FROM PC TO AMIGA FORMAT BY BOB G0LBQ - N6XDI.