** PLEASE READ THIS TEXT COMPLETTLY ** PLEASE READ THIS TEXT COMPLETTLY **
 ** PLEASE READ THIS TEXT COMPLETTLY ** PLEASE READ THIS TEXT COMPLETTLY **
 ** PLEASE READ THIS TEXT COMPLETTLY ** PLEASE READ THIS TEXT COMPLETTLY **

Oberursel, Monday, 19.08.1996

Dear customer,

thank  you  for  buying  our  CyberStorm  MK2 SCSI hosts.  Before using our
controller you must update your CyberStorm MK2 Firmware.  Please do exactly
the following:

1)      SET THE WRITE PROTECTION JUMPER ON YOUR CYBERSTORM MK2

2)	Boot your computer WITHOUT "startup-sequence"

3)	Insert this disk in drive DF0:

4)	Enter "df0:mk2update" at shell prompt, and press return.

5)	The updater should now start. Enter 'Y' to continue update
	operation

6)      The program should now update your Firmware, and indicate its success
        with the message "OPERATION SUCCESSFUL"

7)      REMOVE THE WRITE PROTECTION JUMPER ON YOUR CYBERSTORM MK2


If the update operation should fail, please do the following:

1)	!!!!! DO NOT TURN OFF YOUR COMPUTER !!!!!

2)	Check if the writeprotection jumper is really set.

3)      Start the MK2Update program again (see above)

If  the  update  process  should  fail again, please call technical support
immediatelly.  If your MK2 doesn't work anymore after a cold boot, turn off
your  computer  and  remove the MK2 from your system.  Your board must sent
back to phase 5 repair office to reinstall the firmware.

Much fun and success with our product.

phase 5 support