mount 0.95 by Jurgen Switalski Ph.D.

This is a 1.3 compatable mount command with Workbench support which does not use
the arp library.  The current version supports the following keywords(case 
insensitive):

	HANDLER, FILESYSTEM, DEVICE, PRIORITY, UNIT, FLAGS, SURFACES,
	BLOCKSPERTRACK, RESERVED, PREALLOC, INTERLEAVE, LOWCYL, HIGHCYL,
	STACKSIZE, BUFFERS, BUFMEMTYPE, MOUNT, MAXTRANSFER, MASK, GLOBVEC,
	STARTUP, BOOTPRI, DOSTYPE, SECORG.

The following default values are used:
	BOOT=-128
	STACK=600
	FLAGS=1
	MAXTRANSFER=65536
	MASK=-2
	BOOTPRI=-128
	DOS=$444F5300
All other values are initialized to zero. If you wish to boot from RAD: you
must set BOOTPRI=0.  The from keyword may also be used if the mountlist is not
DEVS:MOUNTLIST.


Comments are allowed and a number of possible errors are checked for and
reported.  However, illegal combinations of keywords or duplicate keywords are
not looked for in this release.  Additionally if GLOBVEC is nonzero it is set
equal to -1.  Also mount may be made resident.

If the device is already mounted and it is a removable media device there may
be a slight delay before mount reports that the device is already mounted
especially if there is no disk in the device.

USAGE:

	mount df3: [ from mymountlist ]
the from keyword is optional, default devs:mountlist. 

Workbench Support:

An icon is supplied to mount devices from Workbench.  To use this from
workbench you must make mount the default tool.  To specify the device to be
mounted and the mountlist the following tooltypes are supported:

	DEVICE=    specifies the device to be mounted.
	FROM=	   the mountlist;  devs:mountlist is the default.

If there any errors a small window will be opened to report errors and will
stay open for two seconds.  Additionally when mount is run from the workbench
mount is set equal to one to force the device driver to load so that an icon
appears on the workbench.

EXAMPLES:

	DEVICE=DF3:
	FROM=DF0:MYMOUNTLIST


I retain copyright to this material and DO NOT warranty it in any fashion! 
This work is SHAREWARE.


	Send all bug reports and any loose change to

		Jurgen Switalski
		218 Lake
		Northville,MI 48167